Publicidad
O
O
FIG. 12
12. Holes are punched in each side panel to mark the locations of the screws for each Hinge Spacer
(S) and Mounting Plate (U). The Doors can be mounted on either side. Since it may be diffi cult to
see the punches through the Hinge Spacers, we recommend that you start a #7x1½" Type 17 Pan
Head Screw (O) into each punch to make the hole easier to see. Remove the screw and insert
through the plates and Hinge Spacers. With the long arm of the Plate facing out, fasten each set
in place with two #7x1½" Type 17 Pan Head Screws (O).
S
Hinge
U
2
FIG. 13
13. To attach the Doors to the unit, slide the Hinge arms onto the Plates as shown in FIGURE 13.
Tighten the screw marked "2" in FIGURE 13A to fasten Hinge.
The Doors may need to be adjusted so all the spaces between the doors and unit sides are equal.
Follow the instructions in FIGURE 13A.
U
Arm
T
DOOR
S
Side
3
2
3
1
FIG. 13A
Side adjustment 4mm (5/32")
To move the door towards the side
panel, loosen screw '1' and tighten
screw '2'. To move the door away
from the side panel, loosen screw
'2' and tighten screw '1'
Depth Adjustment 4mm (5/32")
Loosen screw '2' (Just one turn),
adjust door to desired position,
re-tighten screw.
Height Adjustment 4mm (5/32")
Loosen screw '3', adjust door to
desired position, re-tighten screw.
273W — PAGE 11
Publicidad
