Publicidad
Idiomas disponibles
Idiomas disponibles
5. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If blade screws are overtightened, blades
may crack and break.
Locate 12 blade attachment screws/flat
washers/lock washers in hardware pack.
Turn blade so the end imprinted with THIS SIDE UP
is turned toward the ceiling. Place one blade on the
side of the motor housing as shown, aligning holes
in top and bottom ends of blade with holes on top
and bottom of the motor housing. Insert one blade
attachment screw/flat washer/lock washer into each
hole on the topside of blade with fingers first and
then partially tighten screws securely with a Phillips
screwdriver. Repeat procedure for remaining blades.
Carefully turn motor housing over. Insert one blade
attachment screw/flat washer/lock washer into each
motor screw hole with fingers first and then tighten
screws with a screwdriver. Securely tighten all
12 screws only after all 3 blades have been
attached.
NOTE: Tighten blade attachment screws twice a year.
6. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin and
clip. Lower hanging ball and remove stop pin. Then
slide hanging ball off downrod. [Refer to diagram 1.]
Loosen yoke set screws and nut at top of motor
housing. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack from
the upper end of the downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke set
screws and nut securely. [Refer to diagram 2.]
["Fan Assembly" continued on next page.]
motor
housing
set screw
clip
diagram 1
electrical wiring
downrod
clip
diagram 2
page 6
blade attachment screw/
flat washer/lock washer
"This Side Up" (label)
blade
blade attachment screw/
flat washer/lock washer
stop pin
hanging ball
pin
safety cable
yoke set screw
and nut
pin
motor
housing
Publicidad
