SEWMAQ SW-500 Manual De Instrucciones página 4

EN
3. Settlng the machlne in a working place
Unpack lhe mnchlne together with all parts and accessolies.
A. Posllionlng
Set the machina on a stable surface, preferably on its right, front comer. Fasten the machina to the table edge with clamps,
which are altached to the equipment. The clamp is slipped into front or right groove in the machina.
Choice of locking groove depends upon how user wants to set the machina on the table. Make sure the machina is fixed and
will not fall down from th� table duling work. Figure 2 shows how to fix the machina.
_
B. lnstallation of thread stand
First, loosen the set screw of the thread guide (1) and place the thread guide (2) and bolt assembly (3) in the hole at the back
of the machlne. Then tlghten the sel sc,ew (1 ).
Loosen lhe screw (4) and adjust lhe guide head (5) in the direction of the spool pin (6). Then tighten the screw (4).
Counter screw of the thread guide ( 1)
Fig. 3
4
Thread guide(S)
Thread ide 2
Pin(3)
C. Pedal installation
lnsert the plug of the pedal, with three holes, into an outlet on the right side of the machina, and the electrical plug insert into
the wall outlet.
Pul the pedal on the floor and try to set the speed of the machina by pressing on the pedal.
D. Knee lifter lnstallation
(1) (2)
Put the sleeve on the free end of the shaft and pul the pin
In case of adjusting of the knee lifter, unscrew the set screw (4) and adjust the
screw (4).
Fig. 6
EN
To electric socket
1
(3)
into the groove of lhe L-shaped sleeve.
knee lifter angle. Then t,ghten the set
_
Counter screw {4)
Pivut (J)
. ,