Publicidad
Idiomas disponibles
Idiomas disponibles
9. CARE AND CLEANING
EN
Lower condenser.
For cleaning the condenser follow the
instructions:
>
Open the door or bottom drawer and remove the
magnetic grille.
>
Clean it thoroughly of any dust build up as shown in
the picture, taking care not to damage the condenser.
The edges of the condenser can be
sharp, therefore use adequate protection
for hands and arms when cleaning the
condenser.
26
10. TROUBLESHOOTING GUIDE
10.1 Troubleshooting Guide
If you notice malfunctions in your appliance, use this
guide before calling for service: this guide can help
you personally resolve the problem or could provide
important information to be conveyed to the service
technician to ensure rapid and effective repair.
Display message and audible alarms.
A malfunction is usually indicated by the display.
Problems that cannot be solved by the user are
reported through a fault code. Keep in mind,
however, that in messages or alarms they may
appear for particular conditions of use or during
start-up. In these cases, deactivate the audible
alarm by pressing the Alarm button
and leave the
appliance running and limit the opening of the
doors to the maximum for about 10-12 hours.
The refrigerator does not work.
Is the appliance connected to the electrical power
supply?
Is electrical power available at the electricity socket?
Is the Unit button
activated?
Is the unit in 'Demo' Mode?
The
refrigerator
is
warmer
than
usual.
Does the display show a malfunction code?
Is the temperature adjusted correctly?
Were the doors or drawers open for a long period of
time?
Were large quantities of food recently inserted?
Is the unit in 'Demo' Mode?
Is there something preventing the door or drawer
from closing / sealing properly?
The compressor is running for a long time period.
Bear in mind that during very hot weather and with
very high temperatures in the room it is normal that
the compressor remains on for prolonged periods of
time.
Were the doors or drawers open for a long period of
time?
Were large quantities of food recently inserted?
Check that the doors are closed and that the food or
containers do not obstruct the perfect closure of the
door.
Is one or more compartments in Max Cool Mode?
If you hear unusual noises.
It is normal to hear noises from the fans or
compressors during operation or during the defrost
phase.
Noise could be more marked depending on the
position of the appliance and the surrounding
environment.
Condensation inside and outside of the refrigerator.
If the climate is very humid, the formation of
condensation is normal. Opening the door or drawers
for prolonged periods of time can contribute to the
formation of condensation.
In any case, make sure that the doors are always
completely closed.
Ice or frost build up inside the refrigerator.
Did you leave the doors open for a long period of
time?
Do the doors close completely?
If the doors do not close completely, contact your
installer.
Unpleasant odors inside the refrigerator.
Clean the appliance completely according to the
instructions.
Hermetically cover all the food. Do not conserve food
for prolonged periods of time.
The doors are difficult to open.
The appliance is designed to ensure a fully hermetic
closure. When the door is closed, a vacuum condition
can occur: in this case it is necessary to wait a few
seconds until the pressure balances before opening
the door.
Appliance is cooling but lights and display are not
working.
Check to see if the appliance was accidently placed
into Sabbath Mode.
If the unit you purchased was used as a
showroom model it may be in a special
energy-saving
mode
called
Demo
Mode where the appliance appears
to be operating (lights work and false
temperatures are displayed) but no
cooling actually takes place.
If you
suspect your appliance is in Demo Mode
follow the procedure for disabling Demo
Mode described in this manual.
EN
27
Publicidad
