Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the machine / Using the machine
CAUTION:
Turn OFF the power switch before plugging or
unplugging.
11
Attaching the foot control
1. Insert the power cord plug into the machine socket.
2. Insert the controller plug into the controller plug-in port.
3. Insert the power cord plug into the indoor electrical outlet.
3
1
The foot control regulates the sewing speed. The sewing
speed can be adjusted by increasing or decreasing the pres-
sure on the foot control.
2
This appliance has a polarized plug (one blade wider than
the other).
To reduce the risk of electric shock, this plug is intended to fit
in a polarized main socket only one way.
If the plug does not fit fully in the polarized main socket,
reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper polarized main socket. Do not
modify the plug in any way. (for USA, Canada only)
A
"WARNING''
■ Setting the foot switch
In the initial setting, the foot switch has been set to "half
stitch/low-speed inching stitch".
It is possible to select "chain-off thread cutting" by chang-
ing the setting. (Refer to page 9)
: Half stitch/low-speed inching stitch
• Half stitch
It is possible to sew half stitches by lightly depressing
the foot switch (A).
• Low-speed inching stitch
Press and hold down foot switch (A) to carry out sew-
ing at a low speed.
: Chain-off thread cutting
It is possible to cut chain-off thread by depressing the
foot switch (A).
Publicidad
