Publicidad
Idiomas disponibles
Idiomas disponibles
Check the tightness
of
all
assembly
screws
Change the engine
oil
Check / replace the
air filter
Check/replace the
fuel filter
Inspect
the
hoses/tubes
Check the state of
battery charge
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft cloth for cleaning.
j)
Do not leave the battery in the device if it will not be used for a long time.
Disconnect it from the device by unhooking the negative clamp (black).
k)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
l)
Changing the engine oil:
Before changing the engine oil, it is best to warm it up a little by
•
running the unit for a while. Warm oil is thinner and will therefore
drain faster.
X
(only the first
replacement)
fuel
X
X
X
X
(in case of
working in an
extremely
dusty
environment,
this interval
should be
shortened
accordingly)
X (control)
(change)
X (replace if
necessary)
X
Publicidad
