Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 14

Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
Wheel Guard Installation
Wheel guard must be at-
tached
grinding or cutting wheels. Always keep wheel
guard be tween you and your work while grind-
ing or cutting.
TO ATTACH WHEEL GUARD
Disconnect battery pack from tool.
Press and hold the Release Lever (Fig. 3, 11),
and place the guard on the guard mounting
flange until the guard's keys line up with the
notches in the spindle collar (Fig. 3A).
Press the guard onto the guard mounting flange
until the shoulder of the guard is seated against
the flange of the tool, and turn the guard until it
can clearly be heard to engage.
Adjust the position of the guard to the require-
ments of the work process. For this, press the
release lever upward and turn the guard until it
clicks into place then adjust as needed.
• Always adjust the guard in such a manner that
all 3 red cams of release lever engage into the
corresponding notches of the guard (Fig. 3B).
• Adjust the guard in such a manner that spark-
ing is prevented in the direction of the opera-
tor.
• The guard should turn only upon actuation of
the release lever! Otherwise the tool may not
continue to be used under any circumstances
and must be taken to an after-sales service
agent.
Note: The encoding keys on the guard ensure
that only a guard that fits the tool type can be
mounted.
TO REMOVE GUARD
Press release lever, rotate guard until the keys
on guard line up with the notches on the guard
mounting flange, and lift guard off the guard
mounting flange (Fig. 3).
160992A7PL GWS18V-13CP 202206.indd 14
page heading Assembly
when using disc
-14-
Fig. 3
(11)
Keys
A
Guard
Mounting
Flange
B
6/22/22 2:39 PM