Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 22

Never
locked "ON". Before plug-
ging the tool in, check that the trigger lock is
"OFF". Accidental start-ups could cause injury.
Be aware of the location and
setting of the switch "Lock-
ON" button. If the switch is locked "ON" during
the use, be ready for emergency situations to
switch it "OFF".
Do not use the switch "Lock-
ON" feature in situations
where kickback is likely, such as when working
into a corner. When the wheel binds, the tool
will kick-back in opposite direction of wheel ro-
tation and the release of the trigger "Lock-ON"
may be difficult.
Hold the tool with both
hands while starting the
tool, since torque from the motor can cause
the tool to twist.
Start the tool before applying to work and let
the tool come to full speed before contact-
ing the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch "ON" and "OFF" while the tool is under
load; this will greatly decrease the switch life.
Side Switch with LockON
To turn tool ON:
Press the back of the Side Switch (Fig. 14, 2a)
and slide it forward towards the gear housing
until it comes to a stop and the motor starts run-
ning.
For Lock-ON, when the Side Switch (2a) is in the
ON position, press the front of the Side Switch
and release it. the Side Switch should remain in
the Lock-ON position and the tool will continue
to run.
To turn tool OFF:
Press the rear portion of the Side Switch (2a).
The Side Switch is spring loaded and will return
to the OFF position automatically.
160992A7PL GWS18V-13CP 202206.indd 22
Operating Instructions
leave the trigger
-22-
Paddle Switch
The Paddle Switch (Fig. 15, 2b) has a Lock-OFF
feature to help prevent accidental startups.
To turn tool ON:
Push Lock-Off Switch (3b) forward to unlock the
Paddle Switch, then squeeze Paddle Switch.
To turn tool OFF:
Release pressure on Paddle Switch (2b). The
Paddle Switch is spring loaded and will return
to the OFF position automatically.
Fig. 14
Fig. 15
ON
(2b) (3b)
OFF
(2a)
6/22/22 2:39 PM