Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 16

Lock Nut and Backing Flange
Your tool is equipped with a threaded spindle
for mounting ac ces sories. Always use the sup-
plied quick-clamping nut or the original BOSCH
lock nut (which you can buy separately), and
backing flange, that has the same thread size as
the spindle. Backing flange is keyed to output
shaft (Fig. 4). If you use the original lock nut,
always make sure that the lock nut is tightened
correctly with the supplied wrench.
Disc Grinding Wheel Assembly
Do not use accessories that
run eccentrically. The tool
will vibrate excessively and may cause loss of
control and the accessory may burst.
TO ATTACH GRINDING WHEEL
1. Disconnect battery pack from tool.
2. Be sure that Type 27 Wheel Guard (Fig. 4, 8)
is in place for grinding.
3. Place backing flange and grinding wheel on
the spindle. Make sure the backing flange
locks into the base of the spindle.
4. Thread on the Quick-Clamping Nut (Fig. 4, 9)
and tighten nut using the fold-up bar, while
holding the spindle lock.
TO REMOVE: Reverse procedure.
WHEN USING SPIN-ON WHEELS
Follow steps 1 & 2, then thread wheel directly
onto spindle without using the supplied flanges.
Always make sure that the spin-on wheel is tight-
ened correctly with an open-end wrench (not
supplied).
TO REMOVE: Reverse procedure.
All parts of a spin-on wheel must be within lip of
grinding guard (Fig. 5). If spin-on wheel is past
lip of guard, do not use that wheel as it does not
fit on this grinder.
160992A7PL GWS18V-13CP 202206.indd 16
page heading Assembly
Fig. 4
Type 27
Grinding Wheel
Type 27
Grinding Wheel
Fig. 5
Lip of Guard
-16-
Spindle
(8)
Backing
Flange
Type 27 Spin-On
Grinding Wheel
Lock Nut
(sold separately)
(9)
Spindle
Backing
Flange
Lock Nut
(sold separately)
Spin-On Wheel
6/22/22 2:39 PM