Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 19

Concrete Dust Extraction
Attachment for Surfacing
Grinding Assembly
A type 27 grinding wheel
guard may not be used for
all tool operations. Do not discard guard when
not in use. Always reinstall wheel guard when
converting back to grinding operations.
Dust Extraction Attachment
is not a guard, do not use
with bonded abrasive wheels. Dust extraction
attachment may not protect operator in the
event of a wheel burst.
TO INSTALL CONCRETE DUST EXTRACTION
ATTACHMENT (FIG. 9)
1. Unplug tool from power source.
2. Position appropriate attachment on spindle
neck with dust port pointing away from tool
body.
3. Rotate attachment clockwise 90º until guard
clicks in place.
4. Adjust attachment by depressing guard re-
lease button and rotate to desired position.
5. Allow guard release button to click in place.
6. Place the backing flange on the spindle.
7. Place the diamond cup wheel onto the spin-
dle and align with the flange.
8. Thread the lock nut onto the spindle with the
lock nut relief facing the accessory.
9. Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
When using spin on wheels, follow steps 1 - 5,
then thread wheel directly onto spindle without
using the supplied flanges.
TO REMOVE: Reverse procedure.
160992A7PL GWS18V-13CP 202206.indd 19
page heading Assembly
Fig. 9
Spindle
Wheel
Guard
-19-
Concrete Dust
Extraction
Attachment
Spindle
Neck
6/22/22 2:39 PM