Fasten The Door Bracket; Sectional Doors - Craftsman 139.536481DM Manual Del Propietário

INSTALLATION STEP 11

Fasten the Door Bracket

Follow instructions which apply to your door type as illustrated
below or on the following page.
A horizontal reinforcement brace should be long enough to be
secured to two vertical supports. A vertical reinforcement brace
should cover the height of the top panel.
The illustration shows one piece of angle iron as the horizontal
brace. For the vertical brace, two pieces of angle iron are used to
create a U-shaped support (Figure 1). The best solution is to check
with your garage door manufacturer for an opener installation door
reinforcement kit.
NOTE: Many vertical brace installations provide for direct
attachment of the clevis pin and door arm. In this case you will not
need the door bracket; proceed to Installation Step 12.

SECTIONAL DOORS

• Center the door bracket on the previously marked vertical
centerline used for the header bracket installation. Note correct
UP placement, as stamped inside the bracket (Figure 2).
• Position the bracket on the face of the door within the following
limits:
A) The top edge of the bracket 2"-4" (5-10 cm) below the top
edge of the door.
B) The top edge of the bracket directly below any structural
support across the top of the door.
Header
Bracket
Door
Bracket
Location
Vertical
Centerline
of Garage
Door
Fiberglass, aluminum or lightweight steel garage doors WILL
REQUIRE reinforcement BEFORE installation of door bracket.
Contact your door manufacturer for reinforcement kit.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18
• Mark and drill 5/16" left and right fastening holes. Secure the
bracket as shown in Figure 1 if there is vertical reinforcement.
If your installation doesn't require vertical reinforce ment but does
need top and bottom fastening holes for the door bracket, fasten
as shown in Figure 2.
Inside Edge
of Door or
Reinforcement
Board
23
Lock Washer 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Vertical
Reinforcement
Vertical
Centerline
of Garage
door
Carriage Bolt
5/16"-18x2-1/2"
Door
Bracket
Lock Washer
5/16"
Nut
5/16"-18
Door
Bracket
Door Bracket
Figure 2
Plate
Figure 1