Probuilder 49008 Manual De Instrucciones página 56

Replacing the sanding pad
If the � xed sanding pad becomes damaged or
worn, replace it.
Switch off the wall and ceiling sander at the
mains.
Turn the sander over so that the sanding pad
is facing upwards.
Insert the Allen key (17) into the lock screw (5)
located in the middle of the sanding pad (4)
and turn it anticlockwise.
Remove the lock screw and lift off the worn
sanding pad.
Place a new sanding pad on the axle and
ensure that it is centred.
Secure the sanding pad in place using the
lock screw and check that it rotates freely
without vibrating.
Replacing carbon brushes
If the sander generates an excessive amount
of sparks or if the motor will not start, this
may indicate that the spring-loaded carbon
brushes are worn.
Check the carbon brushes regularly by
removing the carbon brush holders using
a screwdriver and removing the carbon
brushes.
56
Replace the carbon brushes using the extra
brushes provided (18) once they become
worn down.
Both brushes must be replaced at the same
time.
After changing the carbon brushes, the
wall and ceiling sander must be operated
unloaded for 10 minutes.
Cleaning and maintenance
Always switch the wall and ceiling sander off
before cleaning, maintenance and replacing
the sandpaper.
Clean the wall and ceiling sander using a
brush after use.
Never use corrosive or abrasive cleaning
agents, as they may aff ect the plastic parts.
Service centre
Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacement parts
• Returns
• Guarantee issues
• www.schou.com