Puqpress Mini Manual Del Usuario página 15

5. Remove the port-a-filter after a full cycle
of approximately 1.5 seconds.
5.3 Adjusting the tamping force
Adjust the tamping force by using the display
and the buttons.
1. Press the up button to increase the
force.
2. Press the down button to decrease the
force.
NOTICE
The force is displayed in kilograms (kg) or
pounds (lbs).
5.4 Selecting the tamping mode
1. Press and hold the set button for 5
seconds.
2. Use the up and down button to adjust
the setting.
3. Choose between the following settings:
Mini/Q1
Code Setting
P0 SPEEDY
P1 PRECISE
P2 SINGLE
Q2
Code Setting
P0 SPEEDY
Explanation
Normal tamping speed
1.5 seconds
Slow retraction of the
tamper base
Single tamp
Explanation
Normal tamping speed
1.5 seconds
P1 PRECISE
P2 SOFT
P3 HULK
P4 SINGLE
4. Press the set button to confirm the
setting.
5.5 Checking the tamping cycle count
1. When the PUQpress is not in use, press
and hold the up and down button for 3
seconds.
2. The display flashes a number for 5
seconds. Multiply this number by 5,000
to get the tamping cycle count.
5.6 Checking the cleaning cycle count
1. Press the set button.
2. Press and hold the up and down button
for 3 seconds when the PUQpress is in
clean modus.
3. The display flashes a number for 5
seconds. Multiply this number by 20 to
get the cleaning cycle count.
5.7 Switching off the PUQpress
1. Switch off the PUQpress by setting the
on/off switch to O.
2. Unplug the power cable out of the socket
and/or (wall) outlet.
3. Unplug the power cable out of the
PUQpress.
15
EN
Slow retraction of the
tamper base
Slow retraction of the
tamper base, lower
tamping force (5 – 15
kg)
Triple tamp
Single tamp