Hudora BigWheel 205 Advanced Instrucciones De Montaje Y De Uso página 7

• Fold the scooter by first turning the handlebar 180° (with the HUDORA
logo pointing downwards) and then moving it towards the rear wheel
until the transport lock audibly engages. (Picture 6)
• Picture 7 shows the folded scooter.
USAGE INSTRUCTIONS
NOTHING'S EASY AT FIRST ...
... most accidents happen to "beginners" within the first ten minutes.
Particular care should be taken during this stage.
DRIVING INSTRUCTIONS
The scooter moves when a foot is used to regularly push off, just as with
well-known children's scooters. Braking is no problem either - simply
step on the friction brake over the back wheel (mudguard).
We recommend folding the scooter by hand after each use or using the
stand. The side stand is in the direction of movement located on the left
hand side under the deck. Its use is ensured through simply folding and
unfolding. Aluminium is a good and light material but should also be
handled carefully as it is not as hard as steel, for example.
MAINTENANCE AND STORAGE
Use a dry or damp cloth only to clean the product; do not use special
cleaning agents! Check the product for damage or traces of wear and tear
before and after each use. Do not make any structural changes. For your
own safety, please use original spare parts only. These can be sourced
from HUDORA. If parts become damaged or if sharp edges or corners
should develop, the product may not be used any more. If in any doubt,
please contact our service team (http://www.hudora.de/). Store the prod-
uct in a safe place where it is protected from the elements, cannot be
damaged, and cannot injure anyone.
Replace damaged or worn assembly parts in order to ensure the safety
of your scooter.
WHEEL CHANGE
Replacement wheels are available as accessories from http://www.
hudora.de/ and should be replaced when they are worn down. To change
the wheels, loosen the axle fitting with two Allen keys and take the wheels
off the axle. A screwdriver or Allen key can be used to push the bearings
out of the wheel to use them in the new wheel. However, it is usually
advisable to change the bearings when the wheels are changed. Put the
bearings into the new wheel with the bolt spacer and mount them to the
frame with the axle screws. Make sure the axle has been screwed on
tightly before starting again!
BEARINGS
Your kick scooter is equipped with precision ball bearings, which were
filled with grease under high pressure, during manufacture. For this rea-
son, the rollers of the kick scooter only run lightly and swiftly, while under
load. Bearings are maintenance-free, but they are wear parts. Caution!
Worn bearings make conspicuous audible noises and their function is
constrained. In order to maintain optimal riding pleasure and to ensure
lasting safety, you should replace bearings, as soon as they begin to ex-
hibit signs of being worn. In the case of full load and daily use we recom-
mend the replacement of the rollers and bearings twice a year. Bearings
are available as accessories under http://www.hudora.de/.
DISPOSAL ADVICE
At the end of the product's life, please dispose of it at an appropriate col-
lection point provided in your area. Local waste management companies
will be able to answer your questions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise how-
ever, we put just as much effort into rectifying them. Therefore, you can
find numerous information on the product, replacement parts, solutions to
problems and lost assembly manuals at http://www.hudora.de/.
SPARE PARTS AND ORIGINAL
ACCESSORIES AVAILABLE AT:
http://www.hudora.de/
All images are examples of the design.
7/24