SOMFY Sunea 40 Solar io Instrucciones página 10

EN
1] Raise the motorised product to the desired upper position by pressing the Up
button.
ð Pressing and holding the Up button for more than 2 seconds will rise the
motorised product in one continuous movement.
2] Stop the motorised product at the desired point.
3] If necessary, adjust the position of the motorised product using the Up or
Down buttons.
4] Press the my and Down buttons simultaneously until the motorised product
moves.
ð The upper end limit is memorized.
5] Press the my button briefly when the motorised product reaches the desired
lower position.
6] If necessary, adjust the down position using the Up and Down buttons.
ð Pressing and holding the Down button for more than 2 seconds will lower
the motorised product in one continuous movement.
7] Press the my and Up buttons simultaneously until the motorised product
moves.
ð The lower end limit is memorized. The motorised product rises and stops
in the upper position.
8] To confirm the end limits, press the my button until the motorised product
briefly moves up and down.
g The end limits are programmed.
2.3.4.Programming the control point
The drive is in programming mode:
▪ Briefly press the PROG button on the control point to be programmed:
◦ The motorised product moves up and down.
→ The control point is programmed in the drive.
NOTICE
If the drive is no longer in programming mode, repeat Step Pre-programming the control point before performing Step
Programming the control point [
2.3.5."Back impulse" function
NOTICE
- This function allows the fabric to be stretched after each opening movement of the motorised product. It can be
adjusted up to ½ turn of the tube of the motorised product.
- This function can only be activated once the end-limit setting of the drive is completed.
10
} 10].
1]
3]
5]
7]
0.5 s
PROG.
©
Copyright 2022 SOMFY ACTIVITES SA. All rights reserved.
Sunea 40 Solar io
2]
4]
6]
8]