Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
IMPORTANT: Maintenance work must always be done with the machine stopped and with the electrical connector
disconnected. Always wear protective gloves for maintenance operations.
To obtain a nominal amount of product and make efficient use of the machine, it must be cleaned regularly. The intensity
and frequency of the washes will depend on the conditions of the raw material input. Master Products recommends
washing the rack and blades at least once every 4 hours of operation. For optimal cleaning, use hot water and Master
Clean liquid. We recommend washing and sanitizing the other parts of the machine at the end of each working day
(8-12 hours).
NOTE:
Sharpen the blades when cutting efficiency decreases.
Cleaning the blade and the grid
Warning: To perform this operation, it is essential to use protective gloves and follow the safety instructions because
you will be making direct contact with the blade.
Press the ON/OFF switch on the machine to turn it off and
1
disconnect it from the power source. IMPORTANT: The
machine must be stopped and disconnected before
manipulating it.
Unscrew and remove the bolts that link the blade to the
3
motor shaft using an Allen key Nº 3. Then, remove the
blade.
IMPORTANT:
stopped and disconnected before manipulating it.
26
The
machine
must
www.masterproducts.es
Open the three latches of the grid to be able to remove it and have
2
access to the blade.
Proceed with cleaning operation. Hold the blade in the centre
4
to avoid being cut. It is very important to remove the embedded
be
material at the bottom and top of the blade. The accumulation
of raw material debris in this area drastically reduces the cutting
efficiency of the blade.
Publicidad
