Master MB Bucker 500 Manual De Uso Y Mantenimiento página 21

Adjusting the rollers
If branches inserted into the machine head are not drawn in properly, this is due to an incorrect adjustment of the
traction rollers. How to adjust them is described below. All you need is a 24 mm fixed spanner. IMPORTANT: disconnect
the machine from its power supply.
1
Press the red OFF button on the control panel and
disconnect the equipment from the power supply.
IMPORTANT: the equipment must be stopped and
disconnected before manipulating it.
3
Remove the front fairing. IMPORTANT: The equip-
ment must be stopped and disconnected before
handling it in any way.
Tightening the rollers
4
Using a 24mm fixed spanner and the tubular socket
wrench, unscrew and remove the upper nut as
shown in the image (1). Repeat the same process on
the opposite side. See image (2).
Image (1)
2
Loosen the 4 side knobs as indicated in the next
image. IMPORTANT: The equipment must be
stopped and disconnected before handling it in
any way.
X
5
Image (2)
Using the 24mm fixed spanner and the tubular socket
wrench, unscrew the lower nut shown in the image
(1). Look at the image (2) how the rollers come closer
together. Repeat the same process on the opposite
side.
Image (1) Image (2)
20