Master MB Bucker 500 Manual De Uso Y Mantenimiento página 24

1
Disconnect the equipment from its power source.
IMPORTANT: the equipment must be stopped
and disconnected before manipulating it.
3
Select the new position by tilting the upper part of the MB Bucker 500 and fix it by tightening the two bolts on
both sides again using the Allen key Nº 6.
Head functionality
ROUND HEAD
This is suitable for proces-
sing most stems.
The next section explains how to correctly change the heads.
23
2
X
STAR HEAD
This is suitable for proces-
sing highly branched stems
Use an Allen key Nº 6 to unscrew the two rear
bolts marked in the image, enough so that the
machine head can tilt. Do not completely remove
the bolts, just loosen them. MPORTANT: the equi-
pment must be stopped and disconnected
before manipulating it.
TUBULAR HEAD
This is designed for proces-
sing dried raw material.