Publicidad
Idiomas disponibles
Idiomas disponibles
1 - GENERAL WARNINGS
WARNING! Before installing the product, it is mandatory to read the document relating to GENERAL SAFETY
WARNINGS supplied with the product. Document 6-1620001.
The supplementary sheet can also be downloaded from www.allmatic.com.
2 - PRODUCT DESCRIPTION
The control unit BIOS1 24 POWER is suitable for installations with a 24Vdc sliding motor. Its operation is easy and intuitive thanks
to the display interface and the 4 buttons for menu navigation. The control panel allows precise adjustment of all parameters. The
control unit can store up to 1000 transmitters (external memory) with the function step by step, partial opening, open and close. It
is equipped with inputs for photocell opening and closing, safety edge (mechanical or resistive), limit switch closing/ opening and
wired inputs for step, partial opening, open, close and stop. The outputs include a 24 Vac flashing light, 24 Vac courtesy light and
24 Vdc power supply accessories.
The use of buffer batteries is envisaged if it is necessary to ensure the temporary service in the absence of electricity.
CONTROL BOARD
M3
D1
C
• M1: Terminal block connecting security devices and wired
buttons (stop, open, close, partial, step-by-step)
• M2: Terminal block for flashing light, courtesy light, pho-
tocell power supply and accessories. Contact electrical
lock.
• M3: Antenna and shield connection
• D1: DIP SWITCH for disabling unused safety features (ON
= safety disabled)
• T: Keyboard for menu navigation and parameter configu-
ration, 4 keys (MENU, UP, DOWN, SS)
• D: Display LCD
• FC: Mechanical limit switch terminal
• AF: Power supply for magnetic limit switch (optional)
• AS: 24Vac Power supply board (trasformer)
2 / 28
T
LS
LI
M1
R
AF
FC
LL
D
M2
• R: Radio Module
• LS: Security LEDs (PH1, PH2, STOP, EDGE)
ON = NO contact, normal function
OFF = state of alarm
• LI: Wired command's LEDs
(ON = active command, close contact)
• LL: Limit switch LED (ON = limit switch disengaged)
• F1: Fuse T2.5A for flashing protection and courtesy light
• F2: Fuse T0.5A for 24Vdc accessories protection
• F3: Fuse T0.5A for optional battery buffer protection
• CB: Battery charger connector (optional)
• C: Cable connector for communication between power
board and control board
ENG
firmware BIOS124P01
Fig. 1
F1
AS
CB
F2
F3
6-1622399 rev. 1
Publicidad
