Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 32
A
1.
Remove the screw (fi g. 32 A) on the inside of the base.
Fig. 33
1.
Pull the side panel out (fi g. 33 A).
2.
Tilt the side panel gently to the front.
3.
Lift the side panel up.
4.
Replace glass and gasket.
For re-installation follow the same procedure in the opposite
sequence.
6.5 Re-installation of the base door
Fig. 34
2
1
3
A
Fig. 35
If adjusting is needed - see fi gure 29.
7.0 Maintenance
All maintenance must be done when the stove is cold!
7.1 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fi replace during use. Soot is a good insulator and will therefore
reduce the fi replace's heat output. If soot deposits accumulate
when using the product, they can easily be removed by using a
soot remover.
In order to prevent a water and tar layer from forming in the
fi replace, you should regularly allow the fi re to burn hot in order
to remove the layer. An annual internal cleaning is necessary to
ENGLISH
15
Publicidad
