Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
get the best heating eff ect from your product. It is a good idea
to do this when cleaning the chimney and fl ue pipes.
7.2 Sweeping fl ue pipes to the chimney
Flue pipes must be swept through the fl ue pipe sweeping hatch
or through the door opening.
One of the baffl es will have to be removed fi rst in order to do this.
7.3 Inspection of the fi replace
Jøtul recommends that you carefully inspect your fireplace
yourself after it has been swept/cleaned. Check all visible surfaces
for cracks. Also check that all joints are sealed and that the gaskets
are in the correct position. Any gaskets showing signs of wear or
deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Jøtul dealer) and press the gasket well
into place. The joint will dry quickly.
7.4 Exterior maintenance
Painted products may change colour after several years' usage.
The surface should be cleaned and brushed free of any loose
particles before new paint is applied.
Important! Never place anything on the top plate of the stove.
This could cause permanent damage to the paint or enamel.
8.0 Operational problems -
troubleshooting
Poor draught
Check the length of the chimney and that it complies with
national laws and regulations. (See also «2.0 Technical data» ).
Make sure that the minimum cross section on the chimney is
according to «2.0 Technical data» in the installation manual.
Make sure that there is not anything preventing the smoke
gasses from escaping: branches, trees, etc.
Upon suspicion of excessive/poor draught in the chimney, seek
professional help for measurement and adjustment.
16
The fi re extinguishes after a while
•
Make sure that the fi rewood is suffi ciently dry.
•
Find out whether there is negative pressure in the house,
close mechanical fans and open a window close to the
fi replace.
•
Check that the air vent is open.
•
Check that the fl ue outlet is not clogged by soot.
Unusual amount of soot accumulates on
the glass
Some soot will always stick to the glass, but the quantity
depends on:
•
Moisture in the fuel.
•
The local draught conditions.
•
Air vent opening.
Most of the soot will normally burn off when the air vent is
opened all the way and a fi re is burning briskly in the fi replace.
9.0 Optional equipment
9.1 Soapstone top - 50 mm, c0mplete
Cat. no. 50036901
9.2 Steelplate sides, complete
Cat. no. 30023272
9.3 Soapstone set, c0mplete
Cat. no. 50036877
9.4 Fan for Jøtul F 260
Cat. no. 50036914
10.0 Recycling
10.1 Recycling packaging
Your fi replace is delivered with the following packaging:
•
A wooden pallet that can be cut up and burned in the
fi replace.
•
Cardboard packaging that should be taken to a local
recycling facility.
•
Plastic bags that should be taken to a local recycling facility.
10.2 Recycling the fi replace
The fi replace is made of:
•
Metal that should be taken to a local recycling facility.
•
Glass that should be disposed of as hazardous waste.
The glass in the fi replace must not be placed in a regular
source segregation container.
•
Vermiculite burn plates that can be disposed of in regular
waste containers.
Publicidad
