Publicidad
Idiomas disponibles
Idiomas disponibles
The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Sabre saw does not start
Low stroke rate
Stroke rate too high
Sabre saw comes to a stop
during cutting
Centre pin shears off, saw
blade cannot be adequately
clamped
Sabre saw runs slower during
cutting
Other problems
We ask you to send the machine to the manufacturer, if necessary.
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims
in regards to persons or equipment damages are invalid, if one or more of the following causes
apply:
•
Improper use of the machine,
•
improper assembly, startup, operation or maintenance of the machine,
•
operation of the machine with defect safety devices or improperly fixed or non•functioning
safety and protection devices,
•
not considering of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine,
independent structural alterations or settings on the machine beyond the intended purpose,
•
inadequate supervision of wear parts,
•
improperly carried out repairs, inspections or maintenance,
•
catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our
control.
48
TROUBLESHOOTING
Cause
Not connected to compressed
air supply
Operating pressure too low
Hose diameter too small
Flow rate too low
Operating pressure too high
Flow rate too high
Feeding pressure too high
Blunt saw blade Unsuitable
saw blade
Clamp screw worn/
hexagonal socket wrench
worn
Compressed air is not
lubricated – dry run
WARRANTY AND LIABILITY
Remedy
Connecting and opening of the
compressed air supply
Increase operating pressure
Choose larger hose diameter
Increase flow rate
Consider max. operating
pressure acc. to technical
specification
Reduce flow rate
Reduce feeding pressure
Replace saw blade (new)
Replace saw blade
(appropriate for the cut)
Increase operating pressure to
6 bar
Replace clamp screw/
hexagonal socket wrench
Fill the line oiler with oil.
Check oiler setting
(approximately 2•5 drops per
m³/min air consumption)
Contact authorized expert
company
Publicidad
