Simu T5 ZSP Manual Del Usuario página 10

END LIMIT ADJUSTMENT
12
12.1- Adjustment of end limits set in manual mode (UP or DOWN):
UP End limit: SETTINGS 1 & 5 only
DOWN End limit: SETTINGS 1 & 2 only
1- Run the motor to the end limit to be modified.
2- Press and hold the « UP » and « DOWN » buttons simultaneously for 5 seconds until the motor jogs.
3- Adjust the position with the « UP » and « DOWN » buttons.
4- Press 2 s on the « STOP » button to confirm the adjustment, the motor jogs.
The new position is memorized.
12.2- Adjustment of DOWN end limit for products with automatic bottom lock set in manual mode:
SETTINGS: 4 & 5 only.
1 2
5 s
1- Run the motor to the down end limit.
2- Press and hold the « UP » and « DOWN » buttons simultaneously for 5 seconds until the motor jogs.
3- Press the « DOWN » button: product lowers. Press the « STOP » button to stop the product at position (P1),
which corresponds to the automatic latching system's entrance point (the fabric should not be tense).
4- If necessary adjust the position with the « UP » and « DOWN » buttons.
5- Press simultaneously on the « STOP » and « UP » buttons: the motor will run up and then stop, putting tension
on the fabric.
6- Press the « DOWN » button: the motor will run down. Then press the « STOP » button to stop the motor at
position (P2), which corresponds to the automatic locking system's exit point.
7- Press 2 s on the « STOP » button to confirm the settings, the motor jogs.
The new position is memorized.
US
10/12
3
P1
+
6
P2
+
1 2
5 s
4
1
P
2
P
7
1
P
2
P
2 s
3
5
P1
4
2 s
1
P
2
P