Husqvarna RC 318T Manual De Usuario página 29

4. Put a set of bathroom scales below the front edge of
the cutting deck.
5. To make sure the support wheels do not bear
weight, put a block between the frame and the
scales.
6. To adjust the ground pressure, turn the adjustment
screws found behind the front wheels on the right
and left sides.
7. Turn the screws right or left until the ground pressure
is between 12 and 15 kg (26.5-33 lb).
To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is 150
kPa (1.5 bar / 21.8 PSI).
2. Park the product on a level surface.
3. Lower the cutting deck to mowing position.
4. Set the cutting height lever to the middle position.
368 - 006 - 10.11.2022
5. Measure the distance between the ground and the
front and rear edges of the cutting deck and make
sure that the rear edge is 4–6 mm (1/5") higher than
the front edge.
To adjust the parallelism of the cutting
deck
1. Remove the front cover and the right footrest plate.
2. Remove the screws that hold the belt shield and
remove the belt shield.
3. Loosen the nuts on the lift strut.
29