Toshiba TCB-IFDDC201E Manual Del Usuario página 4

1.
Precautions
The manufacturer shall not assume any liability for the damage caused by not observing the description of this manual.
WARNING
General
• Do not modify the products. Do not also disassemble or modify the parts. It may cause a fire, electric shock or injury.
• Before starting to install the air conditioner, read through the Installation Manual carefully, and follow its instructions
to install the air conditioner.
• Only a qualified installer or service person is allowed to do installation work. Inappropriate installation may result in
water leakage, electric shock or fire.
• Do not use any refrigerant different from the one specified for complement or replacement. Otherwise, abnormally
high pressure may be generated in the refrigeration cycle, which may result in a failure or explosion of the product or
an injury to your body.
• Before opening the electrical control box cover of the air handling unit or service panel of the outdoor unit, set the
circuit breaker to the OFF position. Failure to set the circuit breaker to the OFF position may result in electric shocks
through contact with the interior parts. Only a qualified installer (*1) or qualified service person (*1) is allowed to
remove the electrical control box cover of the air handling unit or service panel of the outdoor unit and do the work
required.
• Before carrying out the installation, maintenance, repair or removal work, set the circuit breaker to the OFF position.
Otherwise, electric shocks may result.
• Place a "Work in progress" sign near the circuit breaker while the installation, maintenance, repair or removal work
is being carried out. There is a danger of electric shocks if the circuit breaker is set to ON by mistake.
• Only a qualified installer (*1) or qualified service person (*1) is allowed to undertake work at heights using a stand of
50 cm or more.
• Wear protective gloves and safety work clothing during installation, servicing and removal.
• Do not touch the aluminum fin of the unit. You may injure yourself if you do so. If the fin must be touched for some
reason, first put on protective gloves and safety work clothing, and then proceed.
• When work is performed at heights, use a ladder which complies with the ISO 14122 standard, and follow the
procedure in the ladder's instructions. Also wear a helmet for use in industry as protective gear to undertake the work.
• Before working at heights, put a sign in place so that no-one will approach the work location, before proceeding with
the work. Parts and other objects may fall from above, possibly injuring a person below. While carrying out the work,
wear a helmet for protection from falling objects.
• The refrigerant used by this air conditioner is the R410A.
• The air conditioner must be transported in stable condition. If any part of the product is broken, contact the dealer.
• Do not move or repair any unit by yourself. There is high voltage inside the unit. You may get electric shock when
removing the cover and main unit.
• This appliance is intended to be used by expert or trained users in shops, in light industry, or for commercial use by
lay persons.
Installation
• Install the air conditioner securely in a location where the base can sustain the weight adequately. If the strength is
not enough, the unit may fall down resulting in injury.
• Follow the instructions in the Installation Manual to install the air conditioner. Failure to follow these instructions may
cause the product to fall down or topple over or give rise to noise, vibration, water leakage or other trouble.
• Carry out the specified installation work to guard against the possibility of high winds and earthquake. If the air
conditioner is not installed appropriately, a unit may topple over or fall down, causing an accident.
• If refrigerant gas has leaked during the installation work, ventilate the room immediately. If the leaked refrigerant gas
comes in contact with fire, noxious gas may generate.
• Helmet must be worn to protect your head from falling objects. Especially, when you work under an inspection
opening, helmet must be worn to protect your head from falling objects from the opening.
3-EN
– 3 –