Publicidad
Idiomas disponibles
Idiomas disponibles
DISASSEMBLY
If the whole valve needs to be removed
from the water supply for servicing,
please be aware of the cautions below:
1. Be careful not to lose or tear the
friction washer at the outlet
connection to the vacuum breaker
tube nut. To maintain a proper seal,
replace the washer if necessary.
2. When re-installing the valve to the
water supply, avoid pinching the
o-ring.
CLEANING PISTON ASSEMBLY
1. Turn the screw of the control stop
clockwise to turn off the water.
2. Remove the side screws from top
cover using the tamper resistant
hex wrench (provided).
3. Lift off top cover carefully, and
disconnect the harnesses of the
solenoid and generator.
4. Remove the cap nut using a offset
pipe wrench.
5. Remove the valve cap using a flat
head screwdriver.
NOTE: Be careful not to damage the
solenoid valve or harness
when attaching or detaching
the cap nut or valve cap.
Friction washer
Control stop
Offset pipe
wrench
Flat head screwdriver
Valve cap
- 13 -
Control stop
Snap ring
O-ring
Hex wrench
Cap nut
Valve cap
Publicidad
