Publicidad
Idiomas disponibles
Idiomas disponibles
6. Take out the piston assembly.
NOTE: If you have trouble gripping
the piston assembly, use the
needle nose pliers as shown
in the illustration.
7. Check the small hole in the piston
to see if it is clogged with debris.
Insert a small wire to unclog hole if
needed.
8. Check the filter to see if it is
clogged with debris and gently
brush it clean.
9. Check the sealing area of the
piston and clean it if it is dirty.
10. Check the U-packing for cracks or
damage.
11. Reassemble in reverse order.
NOTE: Please be sure to push the piston all the way down. The top of the piston should sit
approximately 1-1/8" (28 mm) below the rim of the valve. Otherwise the valve cap
will not assemble properly and there is a risk of leakage.
Piston U-packing
Small hole
Filter
TET1GB
TET6GB
TET1UB(X)
TET6UB
TET1LB(X)
TET6LB
Sealing area
- 14 -
Piston
Piston assembly
Cap nut
Valve cap
Publicidad
