Sartorius YDP30 Instrucciones De Manejo página 16

Cleaning and Maintenance
7 Cleaning and Maintenance
7.1 Cleaning Device Surfaces
Procedure
Switch off the device .
t
Disconnect the power supply cable from the power supply
t
at the installation site .
NOTICE Corrosion or damage to the device due to unsuit-
t
able cleaning agents!
Do not use corrosive, chloride-containing or aggressive
t
cleaning agents .
Do not use cleaning agents that contain abrasive
t
ingredients, e .g . scouring agents, steel wool .
Do not use solvent-based cleaning agents .
t
Make sure that cleaning materials, such as cloths, are
t
only slightly damp . Do not use wet cleaning cloths .
Wipe the housing with a slightly damp cloth . Use a mild
t
soapy solution or a suitable cleaning agent for more severe
contaminations .
7.2 Maintenance Schedule
Interval
Before media are inserted
After media are inserted
Monthly
As required
7.3 Removing the Ink Ribbon
Procedure
Switch off the device .
t
Open the top cover .
t
Open the ink ribbon cover .
t
Remove the ink ribbon's paper winding spool from the
t
winding spool for the ink ribbon first on the left side, then
the right .
Remove the ink ribbon's supply spool from the intake for
t
the ink ribbon's supply spool first on the left side, then the
right .
16 Operating Instructions YDP30 | YDP30-NET
Component Action
Print head Remove the ink ribbon .
Clean the print head .
Print roller Remove the media .
Clean the print roller .
Sensors Calibrate the sensors .
Sensors Remove the media .
Clean the sensors .
Tear bar Remove the media .
Clean the tear bar .
Interior Remove the media .
Clean the interior components .
Chapter,
page
7 .3, 16
7 .5 .1, 17
7 .4, 17
7 .5 .2, 17
7 .6, 18
7 .4, 17
7 .5 .3, 17
7 .4, 17
7 .5 .2, 17
7 .4, 17
7 .6, 18