Descargar Imprimir esta página

Sartorius YDP30 Instrucciones De Manejo página 20

Ocultar thumbs Ver también para YDP30:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 99
Malfunctions
8
Malfunctions
8.1
Device Malfunctions
Malfunction
Cause
The LED display is
The device is switched off .
inactive .
The device is not connected to the
power supply at the installation
site .
8.2
Malfunctions when Printing
Malfunction
Cause
The device does not
A print job has been stopped . The
print .
LED display flashes green .
No media have been inserted . The
LED display flashes red .
The inserted media have been used
up .
The ink ribbon has been inserted
incorrectly .
The device does not
The device is not correctly
print (only when used
connected to the testing or
as standard printer) .
laboratory device .
The RS232 connection cable is not
correctly assigned .
The settings for the serial interface
between the device and the
testing or laboratory device differ .
The device does not
The device received multiple print
print (only when used
jobs simultaneously and has only
as network printer) .
printed the first print job .
The device is not correctly
connected to the testing or
laboratory device .
The media shift during
The printer settings are incorrect .
printing .
20
Operating Instructions YDP30 | YDP30-NET
Solution
Switch on the device .
Connect the device to the power supply
at the installation site .
Solution
Press the feed button . This will resume
the print job .
Insert the media .
Remove the media spool .
Insert the media .
Press the feed button . This will resume
the print job .
Remove the ink ribbon .
Insert the ink ribbon .
Check the connection .
Use the supplied printer connection
cable, type RS232 .
If the printer connection cable is
missing: Please contact Sartorius
Service .
Change the configuration for the
"RS232" connection .
Restart the missing print job .
Print the status information .
Check if the device is correctly
configured on the testing or laboratory
device (see the testing or laboratory
device's operating instructions) .
Change the media sensor settings .
Reset the device to factory settings .
Calibrate the sensors .
Chapter, page
5 .4, 12
5 .1, 10
Chapter, page
5 .6 .1, 12
7 .4, 17
5 .6, 12
7 .3, 16
5 .7, 14
5 .2, 11
6 .1, 15
5 .8, 14
7 .6, 18
7 .6, 18
7 .6, 18

Publicidad

loading

Este manual también es adecuado para:

Ydp30-net