Publicidad
Idiomas disponibles
Idiomas disponibles
Charging the product
It is recommended to fully charge the built-in battery of the RGB LED outdoor solar table lamp (1) before
using the product for the first time.
Charging with the USB charging cable
IMPORTANT!
Risk of damage!
Charging the product with an unsuitable USB charger may damage the product.
• Only use USB chargers with max. 5 V output voltage for charging.
1. To charge the product, place it on a dry, horizontal surface that is not sensitive to heat.
2. Unwrap the supplied USB Type C charging cable (4) completely.
3. Open the cover cap (11) on the bottom side of the lampshade (5).
4. Insert the USB Type C plug into the USB Type C charging socket (10).
5. Insert the USB plug into a suitable USB charger or into an active USB socket (e.g., laptop, computer).
During charging, the indicator light on the bottom side of the lampshade (5) lights up red.
The charging time is approx. 4 hours.
When the product is fully charged, the indicator light turns green.
Then remove the USB Type C charging cable (4) and close the cover cap (11).
Charging with the solar panel
1. Place the product outdoors
2. Make sure that the product is not in the shade.
3. Allow the product to charge by direct sunlight on the solar panel (2) for approx. 8 hours.
The charging time depends on the light intensity. If the sky is cloudy, the charging time may be longer. Make sure
that the USB Type C charging cable (4) is not connected to the product during this time.
You can then use the product.
OPERATION IN DETAIL
The RGB LED outdoor solar table lamp (1) is operated exclusively via the pull switch (3) on the lampshade
(5).
• Pull the pull switch once to switch on the product. The luminaire then shines in warm white light at full bright-
ness.
• Pull the pull switch a second time to dim the brightness of the warm white light to 20%.
• Pull the pull switch a third time to switch the product to RGB colour change mode. The light then changes colour
in the following sequence: red – yellow - green – blue – purple. The light colours merge smoothly into one
another, and the brightness is again at 100%.
• Pull the pull switch a fourth time to stop the RGB colour change mode. The lighting then remains in the current
colour.
• Pull the pull switch a fifth time to switch the product off again.
If you then pull the pull switch again, the product is switched on again and the above lighting sequence starts
again.
Please note that the lighting is not dimmable during the charging process via USB charging cable and is at
approx. 30 % of luminosity.
11
USER GUIDE
Publicidad
