Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(1)
Monitor.
(120) Main structure.
(5)
Monitor support.
(50) Side bar (left).
(51) Side bar (right).
(73) Mains cable.
(74) Mains cable fastening cover
(146) Side bar base cover (Left).
(147) Side bar base cover (Right).
(128) Bottle of lubricant.
(17) Bottle holder.
(3)
Self-locking nuts M-8.
(55) Allen screw M-5x15.
(52) Allen screw M-8x75.
(62) Washer M8
(79) Self-tapping screw 3.5x15
(153) Bottle.
Combination box spanner.
Allen key 5mm.
(135) Allen key 6mm.
Follow the instructions step by step to
assemble:
1. At least two people are needed for
this step. When fitting the side bars, one
person should hold the side bar while
the other one tightens the screws (52).
This will prevent any possible accidents.
2. First, take the right-hand side bar
(51), Fig.1.
Insert the tip of the control cable (35)
tying it to the guide cable (N) inserted
in the side bar Fig.1, pull the tip out
through the top of the side bar, as
shown in Fig.1, then insert the side
bar into the bottom right-hand support
on the structure (120) and use screws
(52) to secure it.
3. Now take the left side bar (50) and
insert it into the bottom left-hand
support on the structure (120) and use
screws (52) to secure it.
4 Position the left and right base
covers (146) and (147) in the direction
of the arrow facing the corresponding
side bar, as shown in Fig.2 and attach
them by using screws (55), as shown
in Fig.2.
5. ATTACHING THE MONITOR
TUBE.-
Insert the tip of the control cable (35)
tying it to the guide cable (R) inserted
in the monitor tube Fig.2, pull the tip out
through the top of the monitor tube, as
shown in Fig.2, and making sure not to
pinch any of the cables when inserting
these onto the handrail tubes in the
direction of the arrows. Now tighten
using self-locking nuts (3) Fig.2.
6. ATTACHING THE MONITOR.-
Take
the
terminals (H), (K), (34) and (35),
coming out of the handlebar (5) Fig.3,
to the terminals (J), (141), (140) and
(139), of the monitor, next take the
screws (52) and (175), fit the washers
(62) with the screws (175) and secure
the monitor, making sure not to pinch
the cables.
7. Next, lift the two bottle holder (17)
over the sides of the monitor Fig.4 in
the direction of the arrow.
8. FITTING THE MAINS CABLE.-
Loosen off screws (79) located at the
bottom of the frame (120).
Plug the end of the mains cable (73)
into socket (C) at the bottom front of
the frame (120), Fig.5.
16
monitor
(1),
connect
Publicidad
