Publicidad
Technical Information
Procedure to Connect the Serial and I/O Ports to an
External Cable
The following picture shows the right procedure to connect a cable to the I/O or to
the serial port connector.
A shielded cable of 30 m maximum length has to be utilized for both serial and I/O
port connections.
Take care to have a good contact (soldered) between the metallic connector case
NOTE
and the external shield of the cable. Moreover, this connection has to be assured
at least on the controller side.
In this way, you will be sure to reduce the influence of the external noise and to
accomplish the EMC requests. In picture d is showed the cable assembled.
Figure 43
Agilent TwisTorr Medium-TMP Rack Controller User Manual
167
Publicidad
