Publicidad
PUMP/LINE CLEANING OPERATION
For operation of the pump, please see G56 Beer Pump Installation Instructions (form #81000-303). For nor-
mal dispensing, if a Flow Reversal Valve is added to the pump, the set-up would be as shown in the Typical
Installation Drawing. Note that the valve is in the "Dispense" position (see Valve Positions Drawing). Note:
FRV cannot be used with sponge ball.
For cleaning one line from the faucet to the keg
coupler:
1. Disconnect coupler from keg.
2. Turn the valve to the "Reverse Flow" position.
3. Attach a cleaning jumper to the faucet.
4. Set FOB to bypass mode.
5. Pump the cleaning solution from the faucet to
the keg coupler.
6. Be sure to rinse system with cold, clean rinse
water.
7. After cleaning and rinsing system, connect keg
coupler to the keg, return flow reversal valve and
FOB to normal operating (Dispense) positions.
LINE CLEANING DIAGRAM
Motor
Driven
Pump
Line
Cleaning
Double
Solution
Flusher
For cleaning multiple lines:
(See Line Cleaning Diagram)
1. Attach a cleaning jumper to the first faucet.
2. Turn the valve to the "Reverse Flow" position.
3. Using a double flusher, connect the keg coupler
from the first line to the keg coupler of the sec-
ond line.
4. Leave the valve on the second pump in the "Dis-
pense" position.
5. Connect the second faucet to the third faucet
with a cleaning jumper.
6. Repeat steps 2 through 5 for all lines being
cleaned.
7. Set all FOBs to bypass mode.
8. Circulate cleaning solution through system.
9. Be sure to rinse system with cold, clean rinse water.
10. After cleaning and rinsing system, connect keg
coupler to the keg, return flow reversal valve and
FOB to normal operating (Dispense) positions.
CAUTION: Do not close the system while running
the cleaning pumps. Excessive pressure build-up
could damage pumps.
Recirculating
Line Back To
Cleaning
Solution
Cleaning
Jumper
Double
Flusher
8
Publicidad
