9. Basic issues analyses
Problem
Compressor not working Power not connected
Compressor noisy or
frequently on & off
Not cold enough
LED don't light on
Door cannot close
properly
If you still face issues after checking the above, please contact your service center or dealer.
Replacing Light
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be changed by the
consumer. The lifetime of these LEDs is normally sufficient for no change to be made. If however, and
despite all the care taken during the manufacture of your wine cellar, the LEDs were defective, please
contact your after-sales service for any intervention.
All manuals and user guides at all-guides.com
Problem analyses
Power lead or wire damaged
Fuse broken
Internal circuit fault
Power supply off
In heating process
Power supply not stable
Cabinet not on flat floor
Temperature set too high
Door open too long or too often Only open when necessary
Door gasket damaged
Electric circuit problem
LED damaged
Cabinet not straight
Incorrect door mounting after
changing the door side
Shelf out of the case
Resolve method
Check the power
Contact distributor or service agent
Change fuse
Contact distributor or service agent
Check if power cut
Normal phenomena. When the temperature inside
the cabinet is lower than the settings, the cabinet
will heat automatically
Switch off the power, restart 3 minutes later
Adjust front feet to get the device straight
Check temperature, reset it
Contact your distributor or service agent
Contact your distributor or service agent
Contact your distributor or service agent
Adjust front feet to get the device straight
Mount the door correctly
Put the shelf back to the right position
EN