H i k o n e b | 9 0 8 D C
Us e r Ma n ua l
Return the product to an authorized Drive DeVilbiss service centre for a technical
inspection and repair.
WARNING!
• Keep the power cord away from heated surfaces.
• Never drop or insert any object into any opening or tube.
• Do not use outdoors. This device is designed to be used inside.
• Do not use in an oxygen enriched environment.
• Connect this product to an appropriate electrical outlet only.
• Do not use this product with a DC to AC converter, or with any AC voltage and/or
frequency other than specified.
• The Hikoneb 908 complies with EMC requirements conforming to IEC:60601-1-2.
Nevertheless, location should be considered with caution, when this product is used in
the vicinity of other electronic equipment where electromagnetic interference may be
an issue.
• Make sure that all parts are connected correctly, and that the dust filter is clean.
• A filter which has changed its colour or used a period of 3 months, should be replaced.
• Bacteria filter should be replaced every 48 hours, in between patients and when it
gets dirty.
NOTE!
• Medicine cups (38) are for single use only.
• Dispose of any remaining medicines. Do not use again.
• The device has been designed for inhalation using a mouthpiece or a face mask.
When only using the aerosol tube (for humidification purposes), there should be at least
10cm distance between a patient and the tube.
• Change mouthpiece daily or when changing patient.
• Room/ambient temperature should not exceed 30°C when used with the heater
system (19).
• Only medical clean/sterile water should be used for nebulization.
• Medicines can be nebulized as aqueous solution only.
• The nebulizer chamber (11) is equipped with a maximum and minimum water level
mark. Water should be filled into the chamber between these two marks. If a sterile
water bottle is used, the gasket should be placed completely on the bottle lid, to
prevent flowing water from the chamber. In addition, make sure that the lid is tightly
16