Publicidad
Idiomas disponibles
Idiomas disponibles
3.3. Working with the unit
CAUTION!
complete and as expected! In case of discrepancies, contact the supplier
immediately!
OPERATING THE UNIT:
a)
Connect the power cord to the power output of the unit.
b) Plug the machine into a power outlet.
Turn the unit on by setting the power switch to the "I" position.
c)
Setting the switch to the "0" position will turn off the unit.
d) Set the desired speed of the unit with the knob.
Turn the knob clockwise to increase the rpm,
Turn the knob to the left to decrease rpm.
e) Set the process timer to the desired value.
Turn the knob clockwise to increase the operating time of the process being
carried out,
Turn the knob counterclockwise to decrease the operating time of the process
being carried out.
3.4. Cleaning and maintenance
a)
Pull out the mains plug before each cleaning and when the unit is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
k)
Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
Before working on the unit, make sure that all components are
Publicidad
