Publicidad
Idiomas disponibles
Idiomas disponibles
Alarms:
- sensor failure / out of range temperature alarm - the top line of the
display will show a flashing "E0" instead of the current temperature value
- Too low temperature alarm - the top line of the display will show a
flashing message "E2" instead of the current temperature value
The beeping sound produced by the unit during an alarm can be silenced
by pressing any button on the display.
Overload protection
The device is equipped with a fuse (4) for overload protection.
If the protection is triggered (the device switches off), find the cause and
remove it.
Then replace the fuse with a new one.
Caution: After entering the settings, if the user does not
press any button for about 1 min, the unit will
automatically return to the main screen.
6. Press the cooling switch (C) to start the process of
lowering the system temperature. The compressor will
start after approx. 3 minutes. When the unit has reached
the set temperature inside its system, open the output
from the unit by pressing button (B). On the SBS-LCC-5000
model additionally remember to open the output valve
(12).
7. When you have finished using the unit, turn off the
cooling by pressing button (C) and the display power by
pressing button (D).
Disconnect the unit from the power supply.
Publicidad
