Publicidad
Idiomas disponibles
Idiomas disponibles
**where x - actual temperature value, y - measured value
3.4.
Cleaning and maintenance
a)
Pull out the mains plug before each cleaning and when the unit is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the
housing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the
unit is made.
j)
Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
k)
When not in use for an extended period of time or before storing, empty the
unit's tank of any coolant poured in, following the instructions below.
Dispose of the collected liquid in accordance with local ordinances.
Model
SBS-LCC-3000
Pull the hose extending from the drain hole (7). Place a container for the
liquid, and then open the cap. Drain the liquid, replace the cap, and insert the
hose.
Model
SBS-LCC-5000
Place a liquid container under the outlet valve (12). Open the valve, drain
liquid, and close the valve.
compressor
Publicidad
