Operating Instructions Applications; Before Operation; Working Environment; Air Supply - Metabo HPT NR 38AK Instrucciones Y Manual De Seguridad

APPLICATIONS
● Pre-punched holed metal connector to wood
stud installation only.
● Never drive nails into metal or concrete.
○ Metal hardware with pre-punched holes to wood stud
installation only.
Straps, Joist hangers, framing anchors

BEFORE OPERATION

Read section titled "SAFETY" (pages 4 – 8).
Make sure of the followings before operation.

WORKING ENVIRONMENT

● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.

AIR SUPPLY

● NEVER use reactive gases or
● Never connect
which potentially
(13.7 bar 14 kgf/cm
● Never use non relieving coupler on Nailer.
1. Power source
○ Use only clean, dry, regulated compressed air as a
power source for this Nailer.
○ Air compressors used to supply compressed air to
this Nailer must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
OPERATING INSTRUCTIONS
DANGER
WARNING
DANGER
other bottled
Explosion may occur.
WARNING
Nailer to pressure
exceeds 200
) if a regulator fails.
2
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ............ The fi lter removes moisture and dirt
Regulator ......The regulator controls the operating
Lubricator .... The lubricator supplies an oil mist to the
gases.
Nailer Side
3. Air hose
Compressed air supply hoses shall have a minimum
psi
working pressure rating equal to or greater than the
pressure from the power source if a regulator fails, or
150 psi (10.4 bar 10.6 kgf/cm
4. Air consumption
Using the Air consumption table and the Air
compressor size formula, fi nd a correct compressor
size.
).
2
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
pressure for safe operation of the Nailer.
Inspect the regulator before operation to
be sure it operates properly.
Nailer.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use metabo HPT pneumatic tool
lubricant.
Regulator
Compressor Side
Filter
Lubricator
), whichever is greater.
2
English
11