Adjusting Air Pressure; Loading Nails - Metabo HPT NR 38AK Instrucciones Y Manual De Seguridad

English
(5) With the Nailer off the workpiece, pull the trigger.
Depress the push lever against the workpiece.
□ THE NAILER MUST NOT DRIVE.
(6) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
□ THE NAILER MUST DRIVE PROPERLY.

ADJUSTING AIR PRESSURE

Adjust the air pressure at recommended operating
pressure 80 – 120 psi (5.4 – 8.3 bar 5.5 – 8.5 kgf/cm
according to the diameter of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

● When loading nails into Nailer,
1) do not depress trigger;
2) do not depress push lever; and
3) keep your face, hands feet and other
body parts, as well as those of other
persons away from the nose muzzle to
avoid possible injury during usage and
carrying.
● Always point fi rst nail protruded from the
nose away yourself and others.
Keep your face, hands, feet, other body parts
as well as those of other person away from
the nose muzzle to avoid possible injury
during usage and carrying.
14
WARNING
● Do not exceed
120 psi (8.3 bar
8.5 kgf/cm
WARNING
(1) Insert nail strips from rear of magazine.
).
2
)
2
(2) Slide the nail strip forward in the magazine.
The nail strip should pass over the nail stopper, which
means it is in proper position.
Nail point
Nail Stopper
Nail Strip