MSW Motor Technics MSW-DA-12 Manual página 29

7.3. Using the product
7.3.1. Using the dent removal tabs
• Burning hazard caused by surfaces that may become hot while the product is in use. Never
touch the hot surfaces of the product. The glue gun tip becomes hot while in use.
1. Choose a dent removal tab [#] which is roughly the same shape as the dent, but slightly
smaller than the dent.
2. Apply a small amount of glue on the dent removal tab [#] with the glue gun [#].
Leave approximately 5 mm of free space around the edge of the dent removal tab [#].
3. Place the dent removal tab [#] on the area of the dent.
4. Apply a small amount of pressure on the dent removal tab [#] to ensure that the glue
spreads underneath the dent removal tab [#] and sticks to the body panel.
Do not apply too much pressure. This can cause the glue to push out of the sides of the dent
removal tab [#].
5. Wait a few minutes for the glue to harden. The glue is fully hardened when the dent removal
tab [#] has fully cooled down.
The drying time of the glue depends on the temperature of the working environment.
10