MSW Motor Technics MSW-DA-12 Manual página 30

6. Place the T-Bar [#] or dent lifter [#] over the dent removal tab [#] .
For the bridge puller [#], insert the dent removal attachment [#] into the bridge puller [#].
Use the T-Bar [#] for large sized dents (up to 49 mm).
Use the bridge puller [#] for medium sized dents (up to 39 mm).
Use the dent lifter [#] for small sized dents (up to 30 mm).
7. To remove the dent from the body panel:
• Using the T-Bar [#]:
1. Pull the T-Bar handle and slide the T-Bar puller back and forth to lift the dent.
2. Repeat until the dent is fully lifted.
11