MSW Motor Technics MSW-DA-12 Manual página 26

• Safety hazard. Never use the product if a part is damaged or defective. Replace a damaged
or defective product immediately. Using a defective product can cause moderate injury.
4.3.2. Transport and storage
Risk of damaging the product. Always store the product in a clean, dry, and enclosed place
•
when the product is not used for a longer period of time. Incorrect storage of the product
may cause defects.
4.3.3. Installation
Risk of damaging the product:
• Risk of physical shock of the product. Never drop the product. Always avoid bumping.
Dropping the product may cause damage to the product or the internal electrical parts.
• Risk of damaging the product. Never leave the power cable hanging over the edge of a table
or counter. Prevent the product from being pulled down. Pulling the power cable may cause
damage to the product.
4.3.4. Use
• Fire hazard caused by short-circuiting. Always check if the voltage stated on the type plate of
the product matches with the power outlet voltage.
Electrical shock hazard caused by short-circuiting. Always connect the power cable to a
•
grounded power outlet.
Fire hazard caused by the product that can become hot during use. Never use the product
•
near flammable materials or surfaces. Always keep the product at a minimum distance of 1
meter from flammable materials or surfaces.
• Electrical shock hazard. Never use the product when the power cable is damaged. Always
replace a damaged power cable with an original power cable available from the
manufacturer or the supplier.
• Burning hazard caused by surfaces that may become hot while the product is in use. Never
touch the hot surfaces of the product. The glue gun tip becomes hot while in use.
4.3.5. Maintenance
Electrical shock hazard. Never immerse the product in water or other liquids. Follow the
•
cleaning instructions in this manual for the correct performance of maintenance.
Electrical shock hazard. Never handle the product with wet hands.
•
• Electrical shock hazard. Never perform any maintenance with the power cable connected to
a power outlet. Always disconnect the power cable from the power outlet before cleaning
the product.
• Electrical shock hazard. Never replace the power cable yourself. Always have the power
cable replaced by the manufacturer, a service agent or similar qualified persons.
7