Andis PM-10 Instrucciones De Uso Y Cuidado página 14

comb and snap the comb down (Figures A & B). To remove, simply snap off. These
attachment combs guide hair into the blades and give you precise control of hair
lengths. The two provided attachment combs have adjustable cut lengths: One from
3, 4, 5, 6, 7mm and the other from 8, 9, 10, 11, 12mm. To adjust, press the circle on
the front of the comb slightly and move the comb up or down to your desired cut
length (Figures C & D). Different blade angles in relation to the skin, thickness and
texture of the hair will vary the cutting length.
USER MAINTENANCE
The internal mechanism of your trimmer has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station. To contact Andis directly, please call our Customer
Support Team at 1-800-558-9441 or email us at support@andisco.com.
BLADE TEMPERATURE
Due to the high speed nature of Andis trimmers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
Blades should be oiled before, during, and after each use. If your trimmer blades
leave streaks or slow down, it's a sure sign blades need oil. The trimmer should be
held in a position shown (Figure E) to prevent oil from getting into motor. Place a
few drops of Andis Clipper Oil on the front and side of the cutter blades (Figure F).
Wipe excess oil off blades with a soft, dry cloth. Spray lubricants contain insufficient
oil for good lubrication, but are an excellent trimmer coolant. Always replace broken
or nicked blades to prevent injury. You can clean the excess hair from your blades
by using a small brush or worn out tooth brush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus, while the
trimmer is running. Any excess hair and dirt that has accumulated between the
blades should come out. After cleaning, turn your trimmer off and dry blades with a
soft, dry cloth and start clipping again.
REMOVAL/REPLACEMENT OF BLADE SET
To remove the blade, unplug the trimmer from the electrical outlet. Hold the trimmer
so that the blade teeth are pointing up. Press forward on blade (Figures G & H).
To replace, insert blade back into position and snap back into place (Figure I).
5