Publicidad
INSTRUCTION MANUAL
5-4 BACKLIGHT Function
When the "☼" button is pressed, the backlight will be
turned on. Press the button again to turn the backlight off.
If the button is not pressed again then the backlight will
be automatically turned off in about 30 seconds after it's
turned on.
6. MEASURING INSTRUCTION
6-1 ACA, ACmA Measurement:
(1) Set the range selector switch to the desired position.
The current to be measured should be within the measuring
range.
(2) Normal measurement (see Fig. 1):
Press the clamp opening handle to open the clamp
meter jaws and close them over one conductor only. The
measured current value is shown on the display. Earth
leakage current or any small AC current that flows through
a ground wire can also be measured by this method.
NOTE: Keeping the cable in the center of the clamp will
return more accurate test results when making current
measurements. Zero meter to accurately measure low
milliamp circuits.
(3) Measuring out of balance leakage current (see Fig. 2):
Clamp onto all conductors except the ground wire. The
measured imbalance current value is shown on the display.
Before this measurement, disconnect any test leads from the
meter for safety.
In some cases wherein reading the display is difficult, press
the HOLD button and read the result after the clamp is
removed from the conductors.
I
10
KING INNOVATION
MILLIAMP CLAMP METER
Fig. 1 Normal Measurement:
INCORRECT
Fig. 2 Measuring out of balance leakage current:
LOAD
3-Phase 3-Wire System
CORRECT
LOAD
Single-Phase 2-Wire System
I
KING INNOVATION
11
Publicidad
