Publicidad
INSTRUCTION MANUAL
6-2 ACV Measurement:
WARNING!
Maximum Input Voltage is 600V AC/DC. Do not attempt
to take any voltage measurement that may exceed this
maximum to avoid Electrical Shock hazard and/or
damage to this instrument.
Switch the main function selector to
red test lead to the "+" terminal and the black lead to the
"COM" terminal. Measure the voltage by touching the test
lead tips to the test circuit where the voltage measurement
is required. Read the result from the LCD display.
I
12
KING INNOVATION
ṽ
range. Connect the
MILLIAMP CLAMP METER
6-3 DCV Measurement:
Switch the main function selector to V range. Connect the
red test lead to the "+" terminal and the black lead to the
"COM" terminal. Measure the voltage by touching the
test lead tips to the test circuit where the value of voltage is
needed. Read the result from the LCD display.
6-4 Continuity Test with Buzzer:
Switch the main function to
lead to the "+" terminal and the black lead to the "COM"
terminal. Connect tip of the test leads to the points between
which continuity is to be measured. If the resistance is under
45 Ω, the beeper will sound continuously.
NOTE:
When measuring resistance in a circuit, make sure any power
on the circuit is turned off and any capacitors are discharged.
Short Circuit
Ω range. Connect the red test
Open Circuit
I
KING INNOVATION
13
Publicidad
