Publicidad
INSTRUCTION MANUAL
6-5 Resistance Measurement:
Switch the main function selector to
red test lead to the "+" terminal and the black lead to the
"COM" terminal. Connect tip of the test leads to the points
where the value of the resistance is to be measured. Read
the result from the LCD.
NOTE:
When measuring resistance in a circuit, make sure any
power on the circuit is turned off and any capacitors are
discharged.
7. CHANGING THE BATTERY
When the battery voltage drops below that required for
proper operation of the instrument, the battery symbol will
appear on the LCD display and the batteries should be
changed. Before changing the batteries, switch the main dial
to "OFF" and disconnect test leads. Open the back cover
using a screwdriver. Replace the old batteries with two new
1.5V (AAA Size) batteries. Close the back cover and tighten
the screw before using the meter.
I
14
KING INNOVATION
Ω range. Connect the
MILLIAMP CLAMP METER
NOTE: If the meter is not going to be used for a long time
then remove the batteries and store meter in a cool, dry
location. Do not store meter in a high temperature or high
humidity environment.
8. MAINTENANCE
WARNING!
Before opening the meter, disconnect both test leads.
Never use the meter unless the battery cover is in place
and the screw is tightened.
8-1 Cleaning:
Periodically wipe the case with a dry cloth. Do not use
abrasives or solvents.
I
KING INNOVATION
15
Publicidad
