Endress+Hauser iTEMP TMT82 Manual De Instrucciones página 77

iTEMP TMT82
Expert → Sensor →
Expert → Output →
Expert → Communication →
Expert → Communication →
Expert → Communication →
Endress+Hauser
Menú de configuración y descripción de los parámetros
Diagnostic settings → Corrosion detection
Drift/difference mode
Drift/difference alarm category
Drift/difference alarm delay
Drift/difference set point
Sensor switch set point
Calibration counter start
Calibration alarm category
Calibration counter start value
Count value
Output current
Measuring mode
Lower range value
Upper range value
Out of range category
Failure mode
Failure current
Current trimming 4 mA
Current trimming 20 mA
HART configuration → Device tag
HART short tag
HART address
No. of preambles
Configuration changed
Reset configuration changed flag
HART info→ Device type
Device revision
Device ID
Manufacturer ID
HART revision
HART descriptor
HART message
Hardware revision
Software revision
HART date code
HART output→ Assign current output (PV)
PV
Assign SV
SV
→  87
→  87
→  87
→  88
→  88
→  88
→  115
→  115
→  115
→  116
→  89
→  116
→  83
→  83
→  90
→  90
→  91
→  91
→  91
→  116
→  116
→  117
→  117
→  117
→  117
→  118
→  118
→  118
→  118
→  119
→  119
→  119
→  127
→  119
→  120
→  120
→  121
→  121
77