Rointe NAROS AQUA TNAAN28B180 Manual De Instalacion Y Uso página 9

An installation kit is included in the packaging. Follow the instructions below:
Attach the bleed valve (B) and the blind
tap (C). Use the Rointe bleed valve
wrench (A) to turn the bleed valve (B).
Accurately mark the bracket holes on
the wall using a level. Drill four 8 mm
diameter holes for the upper brackets
(E) and four 8 mm diameter holes for
the lower brackets (F).
Bearings (D) MUST be installed in
each of the brackets (E, F) to avoid
possible noise. Insert the dowels (H)
and screw the brackets (E, F) with Ø
5.5 mm diameter x 45 mm screws (G).
Hang the radiator by sliding the back
of the radiator over the brackets (E, F).
ITEM ELEMENT
A Flush valve wrench
B 1/2" bleeder valve
C Blind tap
D Bearings
E Left bracket
F Right bracket
G Screw Ø 5,5 x 45 mm
H Plugs
4. MAINTENANCE AND CLEANING
The product does not require any maintenance. We recommend cleaning the product (back,
bottom of the product, etc.). Do not use abrasive substances on the product, clean it with
a damp cloth and neutral pH soap and the screen with a dry cloth. Before carrying out any
cleaning operation, make sure that the product is switched off and at room temperature.
NAROS AQUA HYDRAULIC TOWEL RAIL
QN.
1
1
1
4
2
2
8
8
EN
9