Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Lift front of bike to remove tray from
under front axle
3.
Pull the two perforated edges of the
tray down
The front edge will remove
o
completely, while the rear will
remain attached
4.
Install tray in center notches of lower
box and rest the bike, elevated, on the
tray
The black stamped arrow on the
o
tray points toward the front wheel
when installed correctly
5.
Install front fender (RUSH/CTY
models only)
Attach to fork in center hole and
o
tighten to 6.5 Nm using torque
tool. The small rubber washer
should be between fender and
fork. The shortest of the three
screws is for the top fender hole,
while the two longer screws are
for the side forks
Attach both rack supports to
o
forks, making sure the rack
support arm is routed between
the fork and the brake line and
tighten to 6.5 Nm using torque
tool
9
Publicidad
